Bose Videowave III Entertainment Installation Guide - Page 10
Installing the anti-tip straps
View all Bose Videowave III Entertainment manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Physical Setup 7. Route both cords through the leg of the stand and re-attach the connector cover. Leg of stand 8. Plug the AC power cord from the monitor into a live AC (mains) outlet. 9. Restore the connector cover. CAUTION: Bose® strongly recommends installing the supplied two anti-tip straps that, when properly installed, provide an extra measure of security in the event that the monitor accidentally starts to tip over. Installing the anti-tip straps It is important that you install both straps according to the following instructions. WARNING: Do not use the anti-tip straps for any application other than the one specified in this setup guide. CAUTION: If you are unsure of the construction methods used in the space where you are setting up the monitor, or if you do not understand these instructions or have any concerns or questions, please contact a professional installer. 1. Using the provided 5/32 in. (4 mm) hex wrench, remove the top two bolts from the rear panel of the monitor. Bolts to remove 10 - English