Bose Virtually Invisible 191 Installation Guide - Page 18
Secure the speaker to the wall
View all Bose Virtually Invisible 191 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Nederlands Italiano Français Deutsch English STEPS TO INSTALLING Figure 22 Pushing excess wire behind the speaker (a) and Positioning the speaker all the way in the hole (b) 2. Make sure the frame of the speaker is firmly screwed onto the face. The frame prevents the speaker from slipping all the way into the hole. Refer to Figure 17 on page 15 if you need to reverse the frame to orient the Bose logo on the rectangular speaker face. 3. Push the speaker into the hole until the face is straight and flush with the wall (Figure 22b). (a) (b) Secure the speaker to the wall CAUTION: If you use a screw gun to tighten any screws, first select the gun's lowest torque setting (do not exceed 2-4 inch-pounds or 0.2-0.5 N-m of torque). If the screw does not seat properly, finish installing the screw at the next highest torque setting, or by hand. When the speaker is positioned inside the hole with the face straight and flat against the wall, you are ready to tighten the dogleg clamp screws, labeled WALL, along the sides of the frame. The dogleg screws exert pressure from inside to hold the speaker firmly against the wall. Do not confuse the dogleg screws with those labeled GRILLE, which hold the frame. CAUTION: Although they should be thoroughly screwed down, be sure not to overtighten the dogleg screws. Too much compression can crush the wallboard, making it crumble. This creates uneven surface support and can leave gaps between the speaker face and the wall. 1. Slightly tighten the four dogleg clamp screws (Figure 23) until each one begins to grip. This is caused by the clamps that swing out and press against the back of the wallboard. 2. With your fingers grasping the frame of the speaker, rock it slightly back and forth into position. Check for even seating of the face before you tighten the screws any further, and adjust the speaker if it needs to be straightened. Figure 23 Tightening the dogleg clamp screws Dogleg clamp screws GRILLE WALL Dogleg clamps GRWILALLEL 3. When the speaker is straight, tighten each screw. 18