Bose Wave Radio CD Owner's guide - Page 22

Operating Your Wave® radio/CD English Setting the alarms Note: You can set alarms with the Wave® radio/CD on or off. Function To enter alarm setup mode - Press and release Alarm Setup. The system is now in alarm setup mode. ALARM 1 flashes for 10 seconds. To select which alarm to set - While ALARM 1 is flashing, set alarm time, volume, and alarm sound (tone , radio, or CD), for Alarm 1. Press Alarm Setup again until ALARM 2 is flashing. While it flashes for 10 seconds, begin to set Alarm 2. To set the alarm time - While the selected alarm is flashing, press the Time or to set the alarm time. The selected alarm flashes for 10 seconds. To set the alarm source - While the selected alarm is flashing, press FM, AM, or CD Play to select and display that source. The tone is no longer selected. • To reset to tone , press the source currently selected (FM, AM, or CD Play ), which deselects it. • When no source is displayed, the alarm is set to tone . • Setting FM or AM alarm, the station last used for this alarm is shown. Or, use Presets or Track⁄Tune or to select a station. • Setting CD alarm, track 1 is shown. Or, use Track⁄Tune or to select a specific track or time location for the alarm. Press CD Mode to select RANDOM or TRACK REPEAT. The CD plays, repeating as needed, until the alarm shuts off. • To set radio or CD followed by tone , select radio or CD alarm, then press CD Stop I. AUX is not available as an alarm source. To set the alarm volume - While the selected alarm is flashing, press Volume L or M to set the alarm volume, from 10 to 99. The selected alarm flashes for 10 seconds. Time Time Alarm 1 On/Off 1 Alarm Setup Presets 2 Alarm 2 On/Off 3 4 5 6 Track/Tune CD Play CD Stop CD Mode FM AM AUX Stop Alarm Volume Control panel On/Off Sleep/Snooze Wave Radio/CD Alarm Setup Alarm Setup Time Time FM AM CD Play Track/Tune CD Mode CD Stop To test the alarm volume - While the selected alarm is flashing, hold down Alarm Setup and press Volume L or M to hear the volume setting, as demonstrated by the tone alarm only. Alarm Setup To adjust snooze time - The system is set for a standard 10-minute snooze time (the number of minutes you can delay the alarm). While the selected alarm is flashing, hold down Sleep⁄Snooze and press the Time or to adjust the snooze time (from 1 to 30 minutes) for that alarm. The number of minutes and Sn appear on the display to confirm your selected snooze time. You can set a different snooze time for each alarm. Sleep/Snooze Time Time To exit from alarm setup - To leave alarm setup mode, wait 10 seconds for it to disengage. Or you can press AUX once or Alarm Setup a few times until there is no ALARM 1 or ALARM 2 flashing. To check the alarm setting - To display the alarm setting for 10 seconds, press and release Alarm Setup. Press again to display one alarm setup and repeat to display the other alarm setup. Reading the alarm setup displays AUX Alarm Setup Alarm Setup Figure 13 Examples of alarm setup displays 1 Alarm Setup ALARM 1 flashes. You can begin by setting the time. 3 Alarm Setup ALARM 2 flashes. You can begin by setting the time. 2 4 FM CD Play Pressing FM selects it as the source for ALARM 1. Pressing CD selects it as the source for ALARM 2. 20