Boss Audio MCK632WB.6 MR632UAB_EN_UM.PDF - Page 7

Operation

Page 7 highlights

OPERATION During USB or SD card mode, press the '1/>||' button to pause or resume music playback. Press the '2/INT' button to play the first 10 seconds of each track, press again to stop the introduction scan, and play the current track. Press the '3/RPT' button to toggle between RPT ALL (Play all track), RPT FLR (Continuously repeats all tracks in current folder) and RPT ONE (Continuously repeats current track). Press the '4/RDM' button to play all tracks in random order, press again to cancel random playback. 8. CLK Press the CLK button once to display the real time, With time appearing on the display.Press and hold CLK button for more than 2 seconds until the hour flashes. You can adjust the HOUR by pressing the button and button. Then press the CLK button briefly, the minute will flash, you can adjust the MINUTE by pressing the button and button. Finally press the CLK button to confirm the time adjustments. 9. SD CARD SLOT detach T detach Rotate the volume knob to increase or decrese the volume level of the sound output. Press the SEL button on the front panel or on the remote control repeatedly to cycle through the following adjustable audio functions: BASS, TREBLE, BALANCE, FADER, EQ OFF, CLASS/ROCK/POP / FLAT, LOUD ON/OFF, DX/LOC, STEREO/MONO, CLOCK 12/24, AREA US/EU, ILL MID/HI/LOW. ‡5RWDWHWKH92/NQRERQWKHIURQWSDQHORUSUHVVWKH92/92/EXWWRQRQWKHUHPRWHFRQWURO to adjust the selected item. 66aa 75 aa - BALANCE: L7,L6,~, L1, 0, R1,~,R6,R7 - FADER: R7,R6~,R1,0,F1,~,F6,F7 - EQ(Equalizer) Setting: OFF, CLASS, ROCK, POP, FLAT - Loudness: LOUD ON/OFF - DX/LOCAL: Enables or disables the local broadcast mode (LOCAL). - Stereo/Mono: Switches between MONO and STEREO reception mode for radio frequencies. - CLOCK 12/24: Select between 12 hours and 24 hours display. Note: If 12 hour display is selected , AM= Morning; PM= Afternoon - AREA US/EU: This car radio is equipped the USA / Europe frequency. Rotate the volume knob to switch between USA and Europe frequency. The system will change the frequency setting in about 3 seconds. - ILL MID/HI/LOW: This receiver is equipped with 3 brightness settings. Rotate the volume knob to preset the illumination to middle, high or low. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14

OPERATION
5
8. CLK
9. SD CARD SLOT
Press the CLK button once to display the real time, With time appearing on the display.Press and hold
CLK button for more than 2 seconds until the hour flashes. You can adjust the HOUR by pressing the
button and
button. Then press the CLK button briefly, the minute will flash, you can adjust the
MINUTE by pressing the
button and
button.
Finally press the CLK button to confirm the time adjustments.
T
Rotate the volume knob to increase or decrese the volume level of the sound output.
Press the SEL button on the front panel or on the remote control repeatedly to cycle through the
following adjustable audio functions: BASS, TREBLE, BALANCE, FADER, EQ OFF, CLASS/ROCK/POP
/ FLAT, LOUD ON/OFF, DX/LOC, STEREO/MONO, CLOCK 12/24, AREA US/EU, ILL MID/HI/LOW.
to adjust the selected item.
- BALANCE: L7,L6,~, L1, 0, R1,~,R6,R7
- FADER: R7,R6~,R1,0,F1,~,F6,F7
- EQ(Equalizer) Setting: OFF, CLASS, ROCK, POP, FLAT
- Loudness: LOUD ON/OFF
- DX/LOCAL: Enables or disables the local broadcast mode (LOCAL).
- Stereo/Mono: Switches between MONO and STEREO reception mode for radio frequencies.
- CLOCK 12/24: Select between 12 hours and 24 hours display.
Note:
If 12 hour display is selected , AM= Morning; PM= Afternoon
- AREA US/EU: This car radio is equipped the USA / Europe frequency.
Rotate the volume knob to switch between USA and Europe frequency.
The system will change the frequency setting in about 3 seconds.
- ILL MID/HI/LOW: This receiver is equipped with 3 brightness settings.
Rotate the volume knob to preset the illumination to middle, high or low.
detach
detach
During USB or SD card mode, press the ‘1/
>||
’ button to pause or resume music playback.
Press the ‘2/INT’ button to play the first 10 seconds of each track, press again to stop the introduction
scan, and play the current track.
Press the ‘3/RPT’ button to toggle between RPT ALL (Play all track), RPT FLR (Continuously repeats all
tracks in current folder) and RPT ONE (Continuously repeats current track).
Press the ‘4/RDM’ button to play all tracks in random order, press again to cancel random playback.