Brother International 1920CN Service Manual - Page 68
Remove the four screws and take off the guide plate., Remove tape and sponges 1
UPC - 012502607137
View all Brother International 1920CN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
15) Remove the four screws and take off the flat cable clamp. Remove sponge 3 attached with adhesive tape. 16) Remove the CCD flat cable (which is attached with adhesive tape). 17) Remove the four screws and take off the guide plate. 18) Remove tape and sponges 1, then take out the panel harness and CCD HP sensor harness. NOTE: Once removed, the sponges 1 will become unusable and new ones will have to be put back in. IV - 22
IV
- 22
15)
Remove the four screws and take off the flat cable clamp.
Remove sponge 3 attached with
adhesive tape.
16)
Remove the CCD flat cable (which is attached with adhesive tape).
17)
Remove the four screws and take off the guide plate.
18)
Remove tape and sponges 1, then take out the panel harness and CCD HP sensor harness.
NOTE:
Once removed, the sponges 1 will become unusable and new ones will have to be put
back in.