Brother International AX22 User's Manual - English - Page 18
Replacing, Ribbon
View all Brother International AX22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
REPLACING THE RIBBON, ETC. Opening the top cover automatically shuts off the power. The carrier stays where it is. As soon as you close the cover, the carrier moves to the extreme left and then returns to the position it was in when the cover was lifted. If you were printing a document, printing resumes where it left off. Replacing the cassette ribbon Two types of ribbons are available: correctable film ribbon and nylon ribbon. To replace the cassette ribbon O 1) Move the carrier to the center of the platen. 2) Open the top cover. 3) Holding the cassette with both hands, lift the front of the cassette up and out. 4) Move the cassette towards the platen to remove it. 5) Turn the feed knob (on the left side of the cassette) counter-clockwise to tighten the ribbon in the new cassette. 6) Aligning the arrow on the cassette with the arrow on the cassette holder, use both hands to ease the cassette into the holder, back first. 7) Gently press down on the front of the cassette until it clicks into place. ii %.° 8) Again turn the feed knob counter-clockwise to take up any slack. 9) Close the cover. * The amount of tape remaining can be checked through the viewing hole on the right side of 0 the cassette. * Make sure to use only Brother-authorized cassette ribbons, correction tapes and cassette daisy wheels. Brother cannot be held responsible for trouble caused by the use of unauthorized supplies. 14