Brother International DZ1500F Operation Manual - Page 15
Caution
View all Brother International DZ1500F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Bobbin Insertion CAUTION - Moving parts - To reduce risk of injury, turn the power to the machine off before servicing. Open covers. 1 Needle Plate Latch Spring Quick Bobbin Thread Device 1 2 Thread Notch Bobbin Door � Bobbin should be positioned so it winds to the left. 10 cm (4 inches) 3 2 1 Lift needle plate and open bobbin door. 2 1 5 Lower slide plate and close bobbin door, following numbers 1 2 above in order. 2 Put bobbin into the bobbin case. 3 Pull the latch lever of the bobbin 4 Pass the thread through the quick case out and push the bobbin case bobbin thread device in the order 1 ✽✽ Run thread through thread notch and into the shuttle race and release the 2, pull in the direction of the arrow under latch spring, so that a length of latch lever. 3, then cut the thread. thread is exposed. ✽✽ Always use the bobbin case that was supplied with this machine. A secondary bobbin case can be ordered from your dealer. ★ Quick Bobbin Thread Device ✽✽ If the latch lever is not set securely on This device cuts the bobbin thread end the hook, it may fly off during sewing to an appropriate length after the bobbin and cause lower thread breakage. has been replaced and holds it at that Rotate the hand wheel one full length. Following this process eliminates rotation towards you to check that the the need to manually pull the bobbin bobbin case is set securely. thread through the hole in the needle ●● When the fabric extension table is set in place plate. Simply close the bobbin case and Open the bobbin thread setting cover continue the upper threading process. beforehand, then following the above directions set the bobbin thread in place. (You can set the bobbin thread in place without removing the fabric extension table.) Bobbin Thread Setting Cover 13