Brother International DZ1500F Operation Manual - Page 25

Seam Guide, Fabric Separator for, joining lining to fabric

Page 25 highlights

Fabric Separator (for joining lining to fabric) ✽✽ Use this technique for sewing velvet and lining together. 1 Raise needle and foot. 2 Move separator so it sits under presser foot. 3 Make sure it is lined up so that the needle passes through the slot of the separator without hitting the plate itself. 4 Secure liner plate in place with lining plate screws. 5 Set pressure of sewing feet and feed position to pin feeding position. 6 Pull thread until lower needle catches fabric. ✽✽ Sew 2-3 reinforcement stitches. 7 When not using separator, it can be swung off to the side as illustrated in drawing. Needle Seam Guide Separator 1 Tighten the screw securely with a screwdriver since it might otherwise loosen due to vibration. a Fabric Separator Needle Lining Separator Velvets Installation Turn adjustment screws as arrows images suggest to set the position of the Seam Guide foot. Adjustment Note • Lighten the presser foot pressure slightly when using the fabric separator. • Use the separator to neatly sew 2 layers of hard to manage fabrics together by keeping them from interacting with one and other before the needle sews them together in a perfect seam. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

23
Seam Guide
Tighten the screw securely
1
with a screwdriver since it
might otherwise loosen due to
vibration.
a
Installation
Adjustment
Turn adjustment screws as arrows
images suggest to set the position of
the Seam Guide foot.
Fabric Separator (for
joining lining to fabric)
Use this technique for sewing
velvet and lining together.
Raise needle and foot.
1
Move separator so it sits under
2
presser foot.
Make sure it is lined up so that
3
the needle passes through the
slot of the separator without
hitting the plate itself.
Secure liner plate in place with
4
lining plate screws.
Set pressure of sewing feet
5
and feed position to pin feeding
position.
Pull thread until lower needle
6
catches fabric.
Sew 2-3 reinforcement stitches.
When not using separator, it
7
can be swung off to the side as
illustrated in drawing.
Fabric
Separator
Needle
Separator
Needle
Separator
Lining
Velvets
Note
• Lighten the presser foot pressure slightly when using the fabric separator.
• Use the separator to neatly sew 2 layers of hard to manage fabrics together by keeping them
from interacting with one and other before the needle sews them together in a perfect seam.