Brother International Innov-ís 80 Users Manual - English - Page 27
Installing the bobbin
View all Brother International Innov-ís 80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
GETTING READY Installing the bobbin Install the bobbin wound with thread. Press (needle position button) once or a twice to raise the needle, and then raise the presser foot lever. CAUTION ● Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect. a Needle position button Turn off the sewing machine. b ● The bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB(XA5539-151)). 1 4 2 3 a Actual size b This model c Other model d 11.5 mm (7/16 inch) ● Before installing the bobbin or replacing the needle, be sure to turn off the sewing machine, otherwise injuries may occur if start/stop button is accidentally pressed and the machine starts sewing. Slide the bobbin cover latch to the right. c a b a Bobbin cover b Latch X The bobbin cover opens. Remove the bobbin cover. d Hold the bobbin with your right hand and hold e the end of the thread with your left. Memo z The order that the bobbin thread should be passed through the bobbin case is indicated by marks around the bobbin case. Be sure to thread the machine as indicated. • Be careful not to drop the bobbin. 26