Brother International Innov-is 4000D Operation Manual - Page 161
Adjustments During The Embroidery Process
View all Brother International Innov-is 4000D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
ADJUSTMENTS DURING THE EMBROIDERY PROCESS ADJUSTMENTS DURING THE EMBROIDERY PROCESS Note • Be careful not to bump the embroidery unit carriage or the presser foot when removing or attaching the embroidery frame. Otherwise, the pattern will not embroider correctly. If the Bobbin Runs Out of Thread When the bobbin begins to run out of thread during embroidering, the machine will stop and the message below will appear. Press and follow the directions below to rethread the lower threading. If very little sewing remains, you can thread 10 final stitches without rethreading the machine by pressing . The machine will stop after sewing the 10 stitches. b Unlock the frame-securing lever remove the embroidery frame. and * Be careful not to apply strong force to the fabric at this time. Otherwise, the fabric may loosen in the frame. c Insert a wound bobbin into the machine, then reattach the embroidery frame. a Press . d Press . → The carriage will move and the thread will be automatically cut. → The carriage will return to its original position. e To return to the spot in the pattern where you stopped sewing, follow steps c through f in the next section. 150