Brother International Innov-is 6750D Operation Manual - Page 61

Memo • Look in the upper groove area to check if the thread catches on the take-up lever visible inside the upper groove area. UPPER THREADING l Pull the thread up through the to cut the thread, as shown in thread the cutter illustration. 1 Getting Ready a Look in the upper groove area i Pass the thread through the needle bar thread guide (marked "6") by holding the thread with both hands and guiding it as shown in the illustration. a Thread cutter Note • When using thread that quickly winds off the spool, such as metallic thread, it may be difficult to thread the needle if the thread is cut. Therefore, instead of using the thread cutter, pull out about 80 mm (approx. 3 inches) of thread after passing it through the thread guide disks (marked "7"). a Needle bar thread guide j Press the "Presser Foot lower presser foot. Lifter" button to a 80 mm (approx. 3 inches) or more m Press the "Automatic Threading" button to have the machine automatically thread the needle. k Pass the thread through the thread guide disks (marked "7"). Make sure that the thread passes through the groove in the thread guide. a Groove in thread guide → The thread passes through the eye of the needle. Memo • When the "Automatic Threading" button is pressed, the presser foot will be automatically lowered. After threading is finished, the presser foot moves back to the position before the "Automatic Threading" button was pressed. 59