Brother International Innov-is 900D Operation Manual - Page 14
Needle and presser foot, Right-side/rear view
View all Brother International Innov-is 900D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Needle and presser foot section Right-side/rear view a Buttonhole lever (page 90) Lower the buttonhole lever when sewing buttonholes and bar tacks. b Thread guide disk (page 34) Pass the thread through the thread guide disk when using the needle threader to thread the needle. c Needle bar thread guide (page 34) Pass the upper thread through the needle bar thread guide. d Needle plate (page 70) The needle plate is marked with guides for sewing straight seams. e Needle plate cover (page 174) Remove the needle plate cover to clean the bobbin case and race. f Bobbin cover/bobbin case (page 28) Remove the bobbin cover, and then insert the bobbin into the bobbin case. g Feed dogs (page 92) The feed dogs feed the fabric in the sewing direction. h Presser foot (page 43, 54) The presser foot applies pressure consistently on the fabric as the sewing takes place. Attach the appropriate presser foot for the selected stitching. i Presser foot holder (page 45) The presser foot is installed onto the presser foot holder. a Handle Carry the sewing machine by its handle when transporting the machine. b Handwheel (page 54) Turn the handwheel toward you (counterclockwise) to raise and lower the needle to sew one stitch. c Embroidery card slot (page 156) Insert the embroidery card. d USB port (page 170) Connect the one end of the USB cable to this port and the other to the computer. e Air vent The air vent allows the air surrounding the motor to be exchanged. Do not cover the air vent while the sewing machine is being used. f Main power switch (page 17) Use the main power switch to turn the sewing machine on and off. g Foot controller jack (page 56) Insert the plug on the end of the foot controller cable into the foot controller jack. h Power supply jack (page 17) Insert the plug on the power supply cord into the power supply jack. i Drop feed lever (page 92) Use the drop feed lever to lower the feed dogs. Memo z Refer to pages 11 through 14 while you are learning to use your machine. 12