Brother International Innov-is 900D Operation Manual - Page 150
Attaching the Embroidery Frame
View all Brother International Innov-is 900D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
EMBROIDERY Attaching the Embroidery Frame This section describes how to attach the embroidery frame. Attaching the embroidery frame Wind the embroidery bobbin thread onto the a bobbin and set it into the bobbin case. • For details, refer to "Winding/Installing the Bobbin" (page 22). Raise the presser foot lever. b Firmly insert the embroidery frame guide into e the embroidery carriage frame holder from the top. Line up the embroidery frame guide tabs and the embroidery carriage frame holder slots and push in until it clicks and stops. a a a Presser foot lever Press (Needle position button) once or c twice to raise the needle. a a Needle position button Pass the embroidery frame under the presser d foot while raising the presser foot lever even further. b a Embroidery frame guide tabs b Embroidery carriage frame holder slots X The embroidery unit is attached. Note z Be sure to insert both pins. If only the forward or the back pin is inserted, the pattern may not turn out correctly. CAUTION ● Correctly set the embroidery frame into the embroidery frame holder. Otherwise, the presser foot may hit the embroidery frame, resulting in injury. CAUTION ● Do not touch the start/stop button, needle position button or reverse/ reinforcement stitch button. If one of the buttons is accidentally pressed, the machine will begin sewing and your finger may be pricked with the needle or the needle may break. 148