Brother International MD-601 Instruction Manual - English - Page 30
Adjusting, treadle, Einstellen, Pedals
View all Brother International MD-601 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
2.2 Adjusting the treadle 2.2 Einstellen des Pedals 0 A Caution Turn off the power switch before starting work, otherwise the motor may operate, which could result in injury. 0 A Vorsicht Schalten Sie den Netzschalter vor dem Arbeitsbeginn aus, well sonst der Motor unbeabsichtigt eingeschaltet werden und Verletzungen verursachen kann. 2.2.1 Adjusting the treadle pressure O 2.2.1 Einstellen der Pedaldruckkraft * If the machine starts running at a low speed when your Fig A Abbildung A Fig B Abbildung B foot is simply resting on the treadle, or if the treadle pressure is too weak, adjust the position (a to c) at which the treadle spring 0 is hooked onto the treadle lever 0. Note: The treadle pressure will increase from position a to posi- O tion c. * Falls die Maschine zu laufen beginnt, wenn Ihr Fug auf dem Pedal ruht oder die Pedalkraft zu gering empfunden wird, kann die Pedaldruckkraft durch die Position (a bis c), an welcher die Pedalfeder 0 am Pedalhebel 0 eingehangt ist, ein- gestellt werden. Hinweis: Die Pedaldruckkraft nimmt von Position a nach Position c zu. 2.2.2 Adjusting the treadle return pressure 2.2.2 Einstellen der PedalrOckstellkraft * Loosen the nut 0 and turn the bolt 0. The treadle return pressure becomes heavier as the bolt 0 is tightened, and becomes lighter as the bolt 0 is loosened. * Losen Sie die Mutter 0 und drehen Sie die Schraube 0. Durch Anziehen der Schraube 0 wird die Pedalriickstellkraft erhoht, durch L6sen der Schraube 0 wird sie verringert. 2.2.3 Adjusting the treadle stroke 2.2.3 Einstellen des Pedalhubs * Remove the nut 0, and then move the connecting rod joint 0 from the position in figure A to the position in figure B. The treadle stroke will increase by approx. 1.25 times. Note: This adjustment will also affect the treadle pressure and the treadle return pressure, so these settings should be readjusted if necessary. * Entfernen Sie die Mutter 0 und stellen Sie das Zwischenstangengelenk 0 von der Position in Abbildung A in die in der Abbildung B gezeigte Position. Dadurch wird der Pedalhub urn ungefahr das 1,25 fache erhoht. Hinweis: Durch diese Einstellung wird auch die Pedaldruckkraft und die Pedalruckstellkraft beeinfluRt. Daher mussen diese Einstellungen notigenfalls wiederholt werden. - 18 -