Brother International MFC-820CW Quick Setup Guide - English - Page 23

Windows® Wireless Network Installing the Driver & Software Windows® 2 Turn on the machine by plugging in the power cord. Improper Setup If you have previously configured the wireless settings of the machine you must reset the network (LAN) settings before you can configure the wireless settings again. On your machine, press Menu. Press a or b for LAN and press OK. Press a or b for Factory Reset and press OK. Press 1 for Yes to accept the change. The machine will restart automatically. 3 On your machine, press Menu. Press a or b to choose LAN and press OK. Press a or b to choose Network I/F and press OK. Press a or b to choose WLAN and press OK. Press 1 for Yes to accept the change. If Accepted is displayed, press Stop/Exit. The wired network interface will become inactive with this setting. It will take about a minute for the LAN menu on the LCD to become available again. 4 When the LAN menu becomes available, press Menu. Press a or b to choose LAN and press OK. Press a or b to choose Setup WLAN and press OK. Press a or b to choose Setup Wizard and press OK. This will start the wireless setup wizard. 5 The machine will search for your network and display a list of available SSIDs. You should see the SSID you wrote down earlier. If the machine finds more than one network use the a or b keys to choose your network, then press OK. 6 Use the a, b and OK keys to choose one of the options below: If your network is configured for Authentication and Encryption you must match the settings used for your network. No Authentication or Encryption: Choose Open System, press OK then choose None for Encryption Type? and press OK. Then press 1 Yes to apply your settings. Go to step 9. No Authentication with WEP Encryption: Choose Open System, press OK then use the a or b to choose WEP for the Encryption Type? and press OK. Go to step 7. Authentication with WEP Encryption: Choose Shared Key, press OK. Go to step 7. Authentication with WPA-PSK (TKIP) Encryption: Choose WPA-PSK, press OK. Go to step 8. 7 Choose the appropriate key number and press OK. Enter the WEP key you wrote down in step 1 using the dial pad. You can use the d and c keys to move the cursor. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on the dial pad seven times. The letters appear in this order: lower case, upper case, numbers and then special letters. Press OK when you have entered all the characters, then press 1 Yes to apply your settings. Go to step 9. 8 Enter the WPA-PSK (TKIP) key WPA you wrote down in step 1 using the dial pad. You can use the d and c keys to move the cursor. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on your dial pad seven times. Press OK when you have entered all the characters, then press 1 Yes to apply your settings. Go to step 9. 9 Your machine will now try to connect to your wireless network using the information you have entered. If successful, Connected will appear briefly on the LCD. If your machine does not successfully connect to your network, you should repeat steps 3 to 8 to make sure you have entered the correct information. 21