Brother International PE-300S Users Manual - English - Page 37
Needle
View all Brother International PE-300S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Contents Setting Up Basic Sewing Machine Operation Utility Stitches Embroidering NEEDLE CAUTION - Always make sure to turn the machine off before changing needles. There is a danger of injury if the machine accidentally starts running during this operation. - Never use bent or damaged needles. If the needle breaks while sewing, the broken tip could fly away from the machine and cause injury. Checking the needle Place the needle on a flat surface and check whether the space between the needle and the flat surface is parallel or not. 1 If the space is not parallel then the needle is bent and should be thrown away to prevent damage to your project or to the machine. 2 1 Space between the needle and the flat surface 2 Flat surface (needle plate, glass, ruler, etc.) Installing the needle securely 1. Turn off the power. 2. Lower the presser foot. 3. Loosen the needle clamp screw with a screwdriver. Pull out the needle. 1 Disc-shaped screwdriver CAUTION Do not loosen or tighten the needle 1 clamp screw with a strong force, otherwise it way be damaged. 4. With the flat side of the needle facing the back, insert the needle as far as it will go up against the needle stopper. 5. Fasten the screw securely with a screwdriver. 1 Needle stopper 1 Maintenance Troubleshooting Error Messages Sewing Chart Patterns (Programmed in Machine) Patterns (Memory Card) 34