Brother International PT 1950 Users Manual - English and Spanish - Page 57

Error Message Cause Remedy EEPROM ERROR! This message appears if a checksum error occurred when the P-touch was turned on or if the keyword was damaged and it failed to initialize. Contact your service representative. INTERFACE ERROR! This message appears if an error occurs while data is being sent from the computer to the P-touch. Cancel the print job, and then try printing again. INVAL. CHRS! This message appears if the cursor is not below a number when you hold down c and press O. Move the cursor below a number before holding down c and pressing O. LENGTH LIMIT! • This message appears if the text is longer than 3' 3 1/3" (1 meter) when you try to print. • Shorten the text to less than 3' 3 1/3" (1 meter) before trying to print. • This message appears if the Length function is used to set a label length that is less than 1.6" (4.0 cm) or more than 11.8" (30.0 cm). • Set the label length between 1.6" (4.0 cm) and 11.8" (30.0 cm). • This message appears if the Tab Length function is used to set a tab length that is more than 11.8" (30.0 cm). • Set the tab length so that it is less than 11.8" (30.0 cm). LINE LIMIT! This message appears if the number of lines in the text is greater than the maximum number of lines possible for the installed tape. Reduce the number of lines or install a tape of greater width. MEMORY FULL! This message appears if you try to store a text file after the maximum number of characters has already been stored in the memory. Delete an unwanted file to make room for the new one. NO FILES! This message appears if you try to recall or delete a text file from the memory when none are stored. Store a text file first. NO TAPE! This message appears if you try to print a label or feed the tape when no tape cassette is installed. Install a tape cassette and try again. 49