Brother International SL-1110 Instruction Manual - English - Page 12

V-belt, Bobbin winder, Belt cover, V-belt Sold separately

Get Brother International SL-1110 PDF manuals and user guides View all Brother International SL-1110 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

5. INSTALLATION 6. V-belt (1) motor (Sold separately) (2) V-belt (Sold separately) * Turn the two nuts (3) to adjust so that there is 10 - 14 mm of deflection in the V-belt (2) when it is pressed at the midway point with a force of 5 N. 3836M 3837M 7. Bobbin winder 1. Push down the bobbin presser arm (1) as far as it will go. 2. Place the bobbin winder wheel (2) so that it pushes the belt (3) by approximately 5 mm, and then place the bobbin winder (4) so that it is parallel with the belt hole in the table. 3. Install the bobbin winder (4) to the table with the two screws (5). 4. Pull the bobbin presser arm (1) back and check that there is approximately 8 mm of clearance between the bobbin winder wheel (2) and the belt (3). 8. Belt cover 1. Loosen the three screws (1) on the machine side plate by 4 - 5 turns. 2. Tilt back the machine head, align the groove in the belt cover (2) with the stud (3) and the three screws (1), and then securely tighten screw (1)-A only. 3838M 5 SL-1110

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
SL-1110
5. INSTALLATION
5
6. V-belt
(1) motor (Sold separately)
(2) V-belt (Sold separately)
* Turn the two nuts (3) to adjust so
that there is 10 - 14 mm of deflection
in the V-belt (2) when it is pressed at
the midway point with a force of 5 N.
7. Bobbin winder
1. Push down the bobbin presser arm
(1) as far as it will go.
2. Place the bobbin winder wheel (2)
so that it pushes the belt (3) by
approximately 5 mm, and then
place the bobbin winder (4) so that
it is parallel with the belt hole in the
table.
3. Install the bobbin winder (4) to the
table with the two screws (5).
4. Pull the bobbin presser arm (1)
back and check that there is
approximately 8 mm of clearance
between the bobbin winder wheel
(2) and the belt (3).
8. Belt cover
1. Loosen the three screws (1) on the
machine side plate by 4 - 5 turns.
2. Tilt back the machine head, align
the groove in the belt cover (2) with
the stud (3) and the three screws
(1), and then securely tighten screw
(1)-A only.
3837M
3836M
3838M