Brother International SL-1110 Instruction Manual - English - Page 25
Adjusting of the feed dog height, range of 90° with respect to the standard position.
View all Brother International SL-1110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
10. STANDARD ADJUSTMENTS 10-4. Adjusting of the feed dog height 3862M 0.8 mm 1.2 mm The standard height of the feed dog (1) when it is at its maximum height above the top of the needle plate is 0.8 mm for -3 specifications, and 1.2 mm for -5 specifications. Becomes lower Becomes higher 1. Turn the pulley until the feed dog (1) rises to the highest position. 2. Tilt back the machine head. 3. Loosen the screw (2). 4. Turn the feed lifting shaft crank (3) to move the feed bracket (4) up and down. 5. Tighten the screw (2). 3863M 10-5. Adjusting the feed dog angle 3864M Standard The standard angle for the feed dog (1) when it is at its highest position above the needle plate is when the " " mark on the shaft (2) is aligned with the feed rocker bracket arm (3) and the feed dog (1) is parallel to the needle plate. 1. Turn the machine pulley to move the feed dog (1) to its highest position above the needle plate. 2. Tilt back the machine head. 3. Loosen the two set screws (4). 4. Turn the shaft (2) in the direction of the arrow within a range of 90° with respect to the standard position. ・In order to prevent puckering, lower the front of the feed dog (1). (Fig. [A]) ・In order to prevent the material from slipping, raise the front of the feed dog (1). (Fig. [B]) 5. Securely tighten the set screws (4). * The height of the feed dog (1) will change after the angle has been adjusted, so it will be necessary to re-adjust the height of the feed dog (1). Lower the front Raise The front 3865M SL-1110 18