Brother International SL-1110 Instruction Manual - English - Page 24
Adjusting arm thread guide R, 10-3. Adjusting the presser foot height, Remove the oil cap 5.
View all Brother International SL-1110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
10. STANDARD ADJUSTMENTS 10-2. Adjusting arm thread guide R Becomes greater Becomes less The standard position of arm thread guide R (1) is the position where the screw (2) is in the center of the adjustable range for arm thread guide R (1). * To adjust the position, loosen the screw (2) and then move arm thread guide R (1). ・ When sewing thick material, move arm thread guide R (1) to the left. (The thread take-up amount will become greater.) ・ When sewing thin material, move arm thread guide R (1) to the right. (The thread take-up amount will become less.) 3860M 10-3. Adjusting the presser foot height 3861M The standard height of the presser foot (1) is 6 mm when the presser foot (1) is raised by means of the lifting lever (2). 1. Loosen the nut (3) of the adjustment screw (4), and then turn the adjustment screw (4) so that there is no pressure applied to the presser foot. 2. Raise the lifting lever (2). The presser foot (1) will also rise. 3. Remove the oil cap (5). 4. Loosen the bolt (6) and then move the presser bar (7) up or down until the presser foot (1) is at the standard height of 6 mm. 5. Tighten the bolt (6). 6. Replace the oil cap (5). 7. Adjust the presser foot pressure using the adjustment screw (4), and then tighten the nut (3). Needle * After adjusting, check that the needle moves down into the center of the groove in the presser foot. 1257M 17 SL-1110