Canon EOS-1Dx Mark II User Manual - Page 42
Charging the Battery, Connect the charger to a power outlet., Remove the protective cover.
View all Canon EOS-1Dx Mark II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Charging the Battery 1 Connect the charger to a power outlet. Connect the power cord to the charger and insert the power plug into a power outlet. When no battery is attached, all the indicator lamps will be off. 2 Remove the protective cover. As shown in the illustration, detach the charger's protective cover (provided) and the battery's protective cover (provided). 3 Recharge the battery. Slide the battery into the charger's slot as shown by the arrow, and make sure it is securely attached. You can attach the battery to either slot or slot . X Charging will start and the charge lamp will blink or light up in green. X When all three charge lamps light up in green (50%/80%/100%), the charging is complete. To recharge a fully exhausted battery at room temperature (23 °C/ 73 °F), it takes approx. 2 hr. 50 min. for the LP-E19 and approx. 2 hr. 20 min. for the LP-E4N/LP-E4. (The battery recharge time varies widely depending on the ambient temperature and the battery's remaining capacity.) For safety reasons, recharging in low temperatures (5°C - 10°C / 41°F - 50°F) will take a longer time (up to approx. 5 hours only when charging Battery Pack LP-E19). If two batteries are attached to the charger, the battery attached first will be charged first, then the other battery will be charged. Provided Battery Charger LC-E19 can also charge Battery Pack LP-E4N/LP-E4. 42