Home » Canon Manuals » Projectors » Canon REALiS WUX4000 D Pro AV » Manual Viewer

Canon REALiS WUX4000 D Pro AV Multimedia Projector WUX5000 / WUX4000 User's Ma - Page 106

Showing / Hiding the High Temperature Warning Icon, Reducing Flickering

View all Canon REALiS WUX4000 D Pro AV manuals

Add to My Manuals
Save this manual to your list of manuals

Page 106 highlights

Setting Various Functions Showing / Hiding the High Temperature Warning Icon [Other settings] - [Overheat Warning Display] HDMI Digital PC Component Analog PC You can select whether or not to display the [High temperature warning] icon when the temperature inside the projector has increased and is approaching the overheat temperature. System settings Other settings Overheat Warning Display Reducing Flickering [Other settings] - [Deflicker] HDMI Digital PC Component Analog PC This function adjusts the image display in order to reduce flickering in the projected image. • Deflicker can only be used when the lamp has been on for approximately 30 minutes or longer. • Be aware that deflicker may be unable to eliminate flickering in some cases. Other settings System settings Deflicker Off The [High temperature warning] icon is not displayed. On The [High temperature warning] icon is displayed. Press the OK button to accept your setting and then press the MENU button. When [On] is set, the [High temperature warning] icon shown below will be displayed when the temperature inside the projector is abnormally high. Off Deflicker adjustment is not performed. Adjust Select [Deflicker] to adjust. The following screen appears. Screen • [Off] is the factory default. OK Deflicker is performed. Cancel Deflicker is not performed. 106

Section	Page
To Start Menu	2
Quick Reference Guide	3
Table of Contents	4
Safety Instructions	10
Safety Precautions	11
CAUTION ON HANGING FROM THE CEILING	11
READ AND KEEP THIS OWNER’S MANUAL FOR LATER USE.	12
AC Power Cord Requirement	14
Federal Communication Commission Notice	15
Canadian Radio Interference Regulations	15
Precautions for Use	16
Precautions for Installation	17
Precautions on the lamp	19
Precautions for the batteries of the remote control	20
Before Use	23
Supplied Accessories	24
Installing Remote Control Batteries	24
Preparing the Remote Control	26
Remote Control Operating Range	26
Part Names	27
Main Unit	27
Front Side	27
Rear Side	28
Bottom Side	28
Remote Control	30
Side Control	32
LED Indicator Displays	33
Input Terminal	34
User’s Manual (Operation)	35
Projecting an Image	37
Steps for Connecting the Projector and Projecting an Image	38
Connecting the Projector	39
Connecting the Projector to a Computer	39
Connecting to RGB Monitor Output Terminal (Analog Connection)	39
Connecting to DVI Monitor Output Terminal (Digital Connection)	40
HDMI cable (Input signal type: [HDMI] - P48)	41
Outputting Audio to Speakers	41
Connecting to AV Equipment	42
Connecting to Digital Video Output Terminal (Digital Connection)	42
Connecting to Analog Video Output Terminal (Analog Connection)	43
Outputting Audio to Speakers	44
Starting Projection	45
When the Language Selection Screen Appears	46
When the Password Input Screen Appears	46
When “No signal” Appears	46
When Notebook Computer Screen Does Not Appear	47
Adjusting Image	47
Changing Notebook Computer Screen Output	47
Turning on External Monitor Output	47
Selecting an Input Signal (INPUT)	48
Types of Input Signals	48
Selecting an Input Signal	49
Adjusting the Image	50
Setting the Display Resolution of the Computer	50
Windows 7	50
Windows Vista	50
Windows XP	50
Mac OS X	51
AUTO PC	51
Performing the Auto PC Function	51
Selecting Screen Aspect and Aspect	52
Selecting Screen Aspect	52
Moving Image with 16:9 D. Image Shift	54
Moving Image with 4:3 D. Image Shift	55
Resetting the Image Shift	55
Selecting Aspect Ratio	56
Types of Aspect Ratios	56
How to Select an Aspect Ratio	57
Adjusting the Image Size	58
Adjusting the Focus	59
Adjusting the Image Position	60
Resetting the Position	61
Adjusting Keystone Distortion	62
Resetting the Keystone Adjustment	63
Selecting an Image Mode	64
Image Modes	64
How to Select an Image Mode	65
Turning Off the Projector	66
Useful Functions Available During a Presentation	67
Useful Functions Available During a Presentation	68
Temporarily Blacking Out an Image	68
Freezing the Picture	68
Adjusting the Volume	69
Muting the Sound	69
Zooming an Image	70
Showing the Elapsed Time	71
Setting Functions from Menus	73
How to Use Menus	74
Menu Configuration	74
Basic Operation of Menu	75
Setting Display Status	77
Selecting an Image Projection Mode	77
Selecting an Input Signal Type (Analog PC)	78
Selecting an Input Signal Type (Component)	78
Adjust Input Signal (Analog PC) Total dots	79
Adjust Input Signal (Analog PC) Tracking	79
Adjust Input Signal (Analog PC) Horizontal position	80
Adjust Input Signal (Analog PC) Vertical position	80
Adjust Input Signal (Analog PC) Horizontal pixels	81
Adjust Input Signal (Analog PC) Vertical pixels	81
Selecting HDMI Input Level	82
HDMI color format	82
Select HDMI Over Scan	83
Performing Progressive Processing	83
Selecting a Menu Position	84
Correcting the Screen Color	84
Reversing Projection	85
No Signal Screen	86
Screen When Blank	86
Selecting a Logo at Startup	87
Selecting Aspect Ratio of Screen	87
Selecting an Image Quality	88
Image adjustment	88
Saving the Desired Image Quality	89
Adjusting the Brightness	90
Adjusting the Contrast	90
Adjusting the Sharpness	91
Making a Gamma Correction	91
Adjusting Color	92
Correcting the Image According to the Ambient Light	93
Noise reduction	94
Dynamic gamma	94
Memory Color Correction	95
6-axis color adjust	95
Detailed Gamma Correction	96
Reducing the Lamp Brightness	97
Resetting the Image Settings	97
Setting Various Functions	98
Selecting the Power Management Mode	98
Skip the POWER Button Operation	98
Enabling / Disabling the Beep	99
Prohibiting Operations	99
Main Unit and Remote Control Channel Settings	100
Selecting a Display Language	101
Showing / Hiding the Guide Screen	101
Showing / Hiding the Input Status	102
Selecting the HDMI Input	102
Setting a Password	103
Registering a Password	104
Prohibiting Operation of the Lens	104
Lens Shift Reset	105
Extending the Menu Display Time	105
Showing / Hiding the High Temperature Warning Icon	106
Reducing Flickering	106
Resetting the Lamp Counter	107
About the Display of the Lamp Counter	108
Resetting to the Default Setting	109
Checking Projector Information	110
Installation Manual (Installation and Maintenance)	111
Installation	113
Installation Precautions	114
Precautions When Carrying the Projector	114
Installation Precautions	114
Precautions When Carrying and Transporting the Projector	114
When using mounted on the ceiling	116
Install facing in the correct direction	116
Installation Procedure	117
Selecting the Projection Method and Installation Location	118
Ceiling Mounting or Rear Projection	118
Adjusting the projection position when installed on the floor	118
Installing / Removing the Lens Unit	119
Installing the Lens Unit	119
Removing the Lens Unit	123
Setting Up the Projector	124
Positioning the Projector in Front of the Screen	124
Relationship Between Image Size and Projecting Distance	124
Lens Shift Function	126
Connecting to AV Equipment	128
Connectable Equipment and Input Terminals	128
Connection Terminal and Connection Cable	129
Connecting to a Network	131
Preparing the Remote Control	132
Connection Methods	132
Setting an IP Address	133
Windows 7	133
Windows Vista	134
Windows XP	135
Mac OS X	136
Resetting the IP Address Setting of the Computer	136
Network Settings on the Projector	137
Locking the Network Settings	137
Turning On / Off the Network Function	138
Setting a Network Password	138
Registering a Network Password	139
Turning On / Off the PJLink Function	139
Turning On / Off DHCP Function	140
TCP / IP Setting	141
Initializing Network Settings	141
Configuring the Network From the Computer	142
Displaying and Configuring the Network Configuration Screen	142
Resetting to Factory Defaults	145
Setting Errors	145
Setting Up the Network	147
Setting Basic Information [Network]	147
Setting Up Email [Mail]	148
Mail Authentication Settings [Mail auth]	149
Sending a Test Mail [Send test mail]	150
SNMP Settings [SNMP]	150
Setting Projector Information [Projector info.]	151
Setting PJLink [PJLink]	152
Controlling the Projector from a Computer	153
Error Mail	155
Maintenance	157
Cleaning the Projector	158
Cleaning and Replacing the Air Filter	159
Replacing the Air Filter	159
Cleaning the Air Filter	160
Replacing the Lamp	161
Replacement Lamp	162
Replacing the Lamp	162
Appendix	165
Appendix	167
Troubleshooting	168
LED Indicator Meanings	168
Symptoms and Solutions	169
You Cannot Turn on the Projector	169
You Cannot Project an Image from the Projector	169
You Cannot Hear Sound	170
The Projected Image Is Blurred	171
You Cannot Project an Image Appropriately	171
The Projector Power Turns Off	171
You Cannot Operate the Remote Control	172
Relationship between Aspect and Screen Aspect	173
Supported Signal Types	175
Product Specifications	176
Projector	176
Remote control	177
Specification of Each Lens Unit (Option)	177
External View	178
ANALOG PC / COMPONENT IN Terminal	178
Service Port (CONTROL)	179
Index	182
Numerics	182
A	182
B	182
C	182
D	182
F	182
G	182
H	182
I	182
K	182
L	182
M	183
N	183
O	183
P	183
R	183
S	183
T	183
V	183
W	183
Z	183