Canon REALiS WX520 Pro AV User Manual - Page 174
Enabling/Disabling DHCP, Specifying TCP/IP Settings
View all Canon REALiS WX520 Pro AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
Completing Projector Settings Enabling/Disabling DHCP > [Network settings] > [Detailed settings (wired)] > [DHCP] You can turn the projector DHCP function on or off. Specifying TCP/IP Settings > [Network settings] > [Detailed settings (wired) ] > [TCP/IP setting] Configure the projector TCP/IP settings. Off Disables the DHCP function. TCP/IP settings are possible. On Enables the DHCP function. Searches the DHCP server. Because the IP address is acquired from the DHCP server, it is not necessary to enter the TCP/IP settings (IP address, subnet mask, gateway address). Press the OK button to accept your setting and then press the MENU button or EXIT button. • [Off] is the factory default. When [TCP/IP setting] is selected, the window shown below appears. Use the [ ] / [ ] buttons to select the IP address, then press the OK button. Next, use the [ ] / [ ] buttons to select the digit and the [ ] / [ ] buttons to change the value. Press the OK button, then set the subnet mask and gateway address in the same way. Finally, select [Enter]. • The factory default settings are as follows. IP address: 192.168.254.254 Subnet mask: 255.255.255.0 Gateway address: 0.0.0.0 • Settings cannot be made when [DHCP] (P174) is [On]. • If an invalid value is entered, the message "Invalid entry" appears. If this occurs, enter a valid value. 174