Canon REALiS WX6000 D Pro AV User Manual - Page 128

Setting Various Functions Setting a Password [Password settings] HDMI Digital PC Component Analog PC Disables the projector unless the correct password is entered. MENU > [System settings] > [Other settings] > [Password settings] SX6000, the password can be entered using a combination of the numerical buttons and the buttons. [ ] / [1], [ ] / [2], [ ] / [3], and [ ] / [4] have the same function. If the password is valid, the projection starts. If you enter a wrong password three times, the power will be turned off. • The power is also turned off if no password is input for 3 minutes. T o Cancel the P assword Turn off the projector and unplug the power plug. Hold down the MENU button on the side control and connect the power plug. Make sure to keep holding down the MENU button until a beep sounds. When the beep sounds, the password is canceled. (The entered password is also reset.) To forcibly cancel the password from the remote control, in standby state press the MENU button 3 times, then press the POWER button. MENU > [System settings] > [Other settings] > [Password settings] Off The projector can be used even if no password is entered. On The projector cannot be used unless you enter your password. Press the OK button to accept your setting and then press the MENU button or EXIT button (WX6000 / SX6000). • [Off] is the factory default. • You cannot set [On] unless you have com- pleted [Register password]. Once you set a password, the password entry screen appears at power-on. Enter a 4 digit password. For the WUX5000 / WUX4000, the password can be entered using the buttons. For the WX6000 / 128