Canon RP10 for CR-120/150 User Guide - Page 21

[Extended Settings1] tab Specify the print settings and whether to detect the marks on the printed page. [Mark Detection settings] [Mark Detection] Specify how to detect the mark when using paper with a mark. When you select [Each page], mark detection is performed for each page, and then paper is fed to the mark position. When you select [Each document], mark detection is performed for each document, and then paper is fed to the mark position. [Mark Feed lines] Specify the leading edge feed volume after detecting the mark in the range of 13 to 63. Unit: dot per line (1 mm = 8 dots per line) [Extended Settings2] tab Specify the print feed settings and how you want to cut the printed page. [Print settings] [Quality] Select paper that you want to use. Recommended paper is only displayed. [Standard Energy] Specify the print density in the range of 0 to 127. Lower values will result in lighter prints, while higher values will result in darker prints. [Paper Saving] When you select [Each page], the next page is printed successively without leaving bottom margins at the end of each page. When you select [Last page only], the next document is printed successively without leaving bottom margins at the trailing edge of the document. When you select [None], printing is performed using the specified paper length. [Paper Feed settings] [Start of document] Specify the paper feed volume at the start of a document in the range of 0 to 255. Unit: dot per line (1 mm = 8 dots per line) [Start of page] Specify the paper feed volume at the start of a print page in the range of 0 to 255. Unit: dot per line (1 mm = 8 dots per line) 21