Canon RP10 for CR-120/150 User Guide - Page 32

Others • When using a UV lamp frequently, take extra care about paper shrinking due to heat (in the feeding/sub-feeding (paper width) directions), or about color fogging. • The paper surface is slippery. Apply slightly stronger drive roller pressing force. • If you want a higher PCS value for the mark for position detection, perform overprinting. • Depending on the type of preprinted paper, sticking, etc. may occur. Make sure to evaluate such phenomena using the printer that you actually use. Test Print A Press and hold the Power Button to turn OFF the power. B Press the Power Button while pressing the Feed Button to turn ON the power. The test print starts. The test print is performed repeatedly until you stop it. C Press the Feed Button to stop the test print. NOTE The test print stops if a printer error such as "Paper End" or "Paper Cover Open" etc. occurs. Once the error is cleared, the test print resumes. a. 50% checkered pattern printed (2 lines) b. 25% checkered pattern printed (3 lines) c. Status of the internal settings printed The statuses of the interface settings and other advanced settings are printed. d. Japanese character set (12 x 24) (a complete set) e. Standard character set (12 x 24) (a complete set) f. International character set (12 x 24) (a complete set) g. Japanese character set (08 x 16) (a complete set) h. Standard character set (08 x 16) (a complete set) i. International character set (08 x 16) (14 lines) j. Kanji (24 x 24) (15 lines) k. 100-dot feed, partially cut l. 160-dot feed, fully cut 32