Canon VB-S805D Mark II Network Camera Operation Guide - Page 212
Manual, If the Setting in [IPsec Protocol] Includes ESP
View all Canon VB-S805D Mark II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 212 highlights
[IKE Pre-Shared Key] Enter the pre-shared key for IKE (auto key exchange). Manual [IPsec Set] Select which IPsec sets the camera will use; IPv4, IPv6, or neither. [IPsec Mode] Select the IPsec mode. [Destination IPv4 Address], [Destination IPv6 Address] Enter the IP address of the connection destination. [Source IPv4 Address], [Source IPv6 Address] Enter the IP address of the source. [IPsec Protocol] Select the IPsec protocol. If you select [ESP], enter only the setting items relating to ESP. If you select [AH], enter only the setting items relating to AH. If you select [ESP and AH], enter all setting items. [Security Gateway IPv4 Address], [Security Gateway IPv6 Address] Enter the IP address of the security gateway if [IPsec Mode] is set to [Tunnel Mode]. [Destination Subnet Mask Length], [Destination Prefix Length] Enter the subnet mask (IPv4) or prefix length (IPv6) when [IPsec Mode] is set to [Tunnel Mode]. If the Setting in [IPsec Protocol] Includes "ESP" [SA ESP Encryption Algorithm] Set the ESP encryption algorithm to suit the encryption algorithm supported by the device to connect to. Normally [AES] or [3DES] is recommended. [SA ESP Authentication Algorithm] Set the ESP authentication algorithm to suit the authentication algorithm supported by the device to connect to. If [ESP] is used alone, [No Authentication] cannot be selected. [SA ESP Encryption Key (outbound)] Enter the SA encryption key for outbound. If [AES], [3DES] or [DES] was selected in [SA ESP Encryption Algorithm], set a 128-bit, 192-bit or 64-bit hexadecimal number, respectively. This item need not be set if [NULL] was selected. [SA ESP Authentication Key (outbound)] Enter the SA authentication key for outbound. If [HMAC_SHA1_96] or [HMAC_MD5_96] was selected in [SA ESP Authentication Algorithm], set a 160-bit or 128-bit hexadecimal number, respectively. This item need not be set if [No Authentication] was selected. [SA ESP SPI (outbound)] Enter the SA SPI value for outbound. Set a desired value in the range of 256 to 4294967295. [SA ESP Encryption Key (inbound)] Enter the SA encryption key for inbound. If [AES], [3DES] or [DES] was selected in [SA ESP Encryption Algorithm], set a 128-bit, 192-bit or 64-bit hexadecimal number, respectively. This item need not be set if [NULL] was selected. [SA ESP Authentication Key (inbound)] Enter the SA authentication key for inbound. If [HMAC_SHA1_96] or [HMAC_MD5_96] was selected in [SA ESP Authentication Algorithm], set a 160-bit or 128-bit hexadecimal number, respectively. This item need not be set if [No Authentication] was selected. [SA ESP SPI (inbound)] Enter the SA SPI value for inbound. Set a desired value in the range of 256 to 4294967295. 194