Canon imagePROGRAF iPF770 Setup Guide - Page 2

Preparations Prepare the printer for use by assembling the stand and connecting the power cord. 1 Assemble the stand. Refer to the Stand Setup Guide included with the stand for details on how to assemble the stand. Once you have finished, proceed to step 4. A stand is optional for the iPF670 series. (It may be included as a standard accessory in some locations.) If you are using the iPF670 series without a stand, proceed to step 2. 2 Remove the packing materials from the top of the printer. 3 Three people should hold the printer's carrying handles and place the printer on a table or other flat location. • The iPF770 Series weighs approximately Caution 53 kg and the iPF670 Series approximately 43 kg by themselves. Moving the printer requires at least three people. Be careful to avoid back strain and other injuries. • When moving the printer, firmly grasp the carrying handles. Holding the printer at other positions is dangerous, and may cause injury and damage if the printer is dropped. 4 Remove the orange tape used to secure the roll holder to the printer. • When setting the printer down temporarily make sure to put the printer on a flat, stable place. • The way to set the printer down or to carry with the load only to the center of the printer, may cause damage to the printer. 5 Move the printer to the location where you will use it. • When moving the stand, lift the support rod Caution to the position (a) before closing the output stacker and unlocking the 4 casters. Failure to do so may lead to scratched flooring, damage to the basket cloth, and injury. a OFF • After you have moved the stand, be sure to lock the 4 casters. ON 6 Plug the power cord into the power supply connector on the right of the printer and plug the other end into the outlet. 2