Canon imagePROGRAF iPF770 Setup Guide - Page 3

Install the Ink Tanks Install the 6 ink tanks. 1 Press the power button to turn on the printer. 2 When the following screen appears, use the ▲ and ▼ keys to select a language and press OK. Language 㻝㻛㻞 English ᪥ᮏㄒ Data Message Français Italiano Deutsch 3 Select your local time zone and press OK. Time Zone 㻝㻛㻡 0:London (GMT) +1:Paris,Rome +2:Athens,Cairo Data +3:Moscow Message +4:Eerevan,Baku Load FEED Cut Power Menu Back Stop Navigate 4 Instructions on ink tank installation are shown on the display screen. As instructed, grab the handle on the ink tank cover to open it. 5 While pressing the stopper of the ink tank lock lever inwards, open the ink tank lock lever upwards. 6 Shake the ink tanks gently 1 to 2 times before opening the pouch. 7 Open the pouch and remove the ink tank. • Failure to shake ink tanks may result in reduced print quality because ink ingredients have settled on the bottom of the tank. • If the ink tank is cold, allow it to adjust to room temperature before attaching it to the printer. 8 Insert the ink tank into the holder facing as shown, with the ink holes down. At this time, detach and reattach the ink tanks 2 to 3 times and ensure that the ink tanks are security attached. 9 Close the ink tank lock lever until it clicks into place. Make sure the ink lamp is lit in red. • Never touch the ink holes (a) or metal contacts (b). Touching these parts may cause stains, damage the ink tank, and affect print quality. a b • Avoid dropping the ink tank after removing it from the pouch.Otherwise, ink may leak and cause stains. • Do not remove and shake ink tanks that have already been installed in the printer because ink may leak out. • If the ink tank does not fit in the holder, make sure the color of the ink tank lock lever matches the color of the ink tank, and check the orientation of the ink tank. • If the ink lamp is not lit, repeat steps 5 and 9. 10 Repeat steps 5 to 9 to install all of the ink tanks. 11 Close the ink tank cover.