Canon imagePROGRAF iPF8300S iPF8300S Basic Guide No.2 - Page 43

Error Messages Error Message Cause Corrective Action Rewinding error. There is some foreign object near Remove the foreign object near the sensor. the Media Take-up Unit sensor and the roll cannot be detected. The Media Take-up Unit sensor is soiled and the roll cannot be detected. Wipe the sensor with a dry cloth to clean it. The roll is out of range of detection Reload the roll. by the Media Take-up Unit sensor. (→ , Loading Rolls in the Printer) The Media Take-up Unit sensor is Contact your Canon dealer for assistance. damaged. A paper jam has occurred and the Remove the paper from the Media Take-up Unit. roll cannot be rewound. Press the OK button to clear the error. Turn on the media take-up unit. The Media Take-up Unit was off when you selected Enable for Take-up Reel. Turn on the Media Take-up Unit. Media take-up unit ready. The Take-up Reel setting in the printer Set./Adj. Menu was changed from Enable to Disable, but a print job was received before the roll was removed. Press ▲ or ▼ to select Stop Printing, and then press the OK button to stop printing. The mode switches from take-up mode to regular mode after you change the Take-up Reel setting in the Set./Adj. Menu from Enable to Disable and lift the Release Lever to remove a roll, or after you execute Paper Cutting. Press ▲ or ▼ to select Print, and then press the OK button to resume printing. Multi-sensor error Direct sunlight or strong lighting Take steps to ensure the printer is not used when may be shining on the printer and exposed to direct sunlight or strong lighting. causing the sensor to malfunction. The performance of a sensor Contact your Canon dealer for assistance. inside the printer may be impaired. Maint. cart. The level is low The Maintenance Cartridge is almost full. You can continue to print, but prepare a new Maintenance Cartridge to use when the message for replacement is displayed. Maintenance cartridge problem. An incompatible or used Maintenance Cartridge has been installed. Install an unused Maintenance Cartridge specified for use with the printer. (→ , Replacing the Maintenance Cartridge) Maintenance cartridge full. The Maintenance Cartridge is full. After confirming that the printer has stopped operating, replace the Maintenance Cartridge. (→ , Replacing the Maintenance Cartridge) No maintenance cartridge. The Maintenance Cartridge is not Install the Maintenance Cartridge. installed. (→ , Replacing the Maintenance Cartridge) Wrong maintenance cartridge. A Maintenance Cartridge for a different model of printer is installed. Replace it with the Maintenance Cartridge for your particular model. No Maintenance Cartridge capacity. The Maintenance Cartridge cannot After confirming that the printer has stopped absorb enough ink for Printhead operating, replace the Maintenance Cartridge. cleaning or other operation. (→ , Replacing the Maintenance Cartridge) 43