Canon imagePROGRAF iPF8400SE User Guide - Page 660

PaprWidth Mismatch Cause The loaded paper is too small. (When you have attempted to print a test print sheet or other printer status information.) Corrective Action Press ▲ or ▼ to select Stop Printing, and then press the OK button. iPF8400SE "Replace roll with 10 in. wide or larger roll." Cause The loaded paper is too small. (When you have attempted to print a test print sheet or other printer status information.) Corrective Action Replace the roll with a roll 10 inches in width or larger as follows. 1. Press ▲ or ▼ to select Change Paper, and then press the OK button. (See "Removing the Roll from the Printer.") ➔P.372 (See "Removing the Roll Holder from Rolls.") ➔P.375 2. Replace the roll with a roll 10 inches wide or larger. (See "Loading Rolls on the Roll Holder.") ➔P.363 (See "Loading Rolls in the Printer.") ➔P.366 The printer will resume printing. Press ▲ or ▼ to select Stop Printing, and then press the OK button. Error Message PaprWidth Mismatch Cause When Detect Mismatch in the Control Panel menu is set to Pause or Hold Job, the width of the loaded roll does not match the width specified in Fit Roll Paper Width in the printer driver. Corrective Action Press ▲ or ▼ to select Print, and then press the OK button to resume printing. However, note that this error may cause paper jams and affect the printing quality. Press ▲ or ▼ to select Stop Printing, and then press the OK button. Follow these steps to replace the roll to match the width specified in the printer driver. 1. Press ▲ or ▼ to select Change Paper, and then press the OK button. (See "Removing the Roll from the Printer.") ➔P.372 (See "Removing the Roll Holder from Rolls.") ➔P.375 2. Replace with paper of the width configured in the printer driver. (See "Loading Rolls on the Roll Holder.") ➔P.363 (See "Loading Rolls in the Printer.") ➔P.366 The printer now starts printing the print job. Make sure the roll width selected in the dialog box displayed when you select Fit Roll Paper Width in the printer driver matches the width of the roll loaded in the printer, and then try printing again. Messages regarding paper Paper size not detected. Cause Paper has been loaded askew, or warped paper has been loaded. 660 Corrective Action Lift up the Release Lever and reload the paper. (See "Loading Rolls in the Printer.") ➔P.366 (See "Loading Sheets in the Printer.") ➔P.389 If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly in until it touches the Roll Holder flange, and reload the Roll Holder in the printer. (See "Loading Rolls on the Roll Holder.") ➔P.363 User's Guide