Canton DM 20 Owners Manual - Page 45
m => System Setup => Output Config => Volume - manual
View all Canton DM 20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Espagnol Français English Deutsch DM System - Functions No inputs except "radio" can be selected 1. No inputs have been registered in the "input config" menu (e.g. initial installation was terminated with "exit") 2. During the configuration process the "up" or "down" arrow keys and / or the "exit" key were used DM System does not recognise Dolby Digital or DTS data stream 1. The source is only connected to the analog port (Line 1 or 2) 2. The wrong settings have been selected on the source device No signal from Zone2 / Line - Output 1. There should be a multi-channel signal from Zone2 / Line RC only displays "surround" instead of "surround 1" and "surround 2" 2. The volume for Zone2 is set too low 1. The DM System has been set to 4.1 or 5.1 mode 1. Register the relevant inputs in the "input config" menu (m => System Setup => input config). Follow the exact instructions on page 36! 2. Register the relevant inputs in the "Eingangskonfig" menu (m => System Menu => Eingangskonfig) and only use the correct keys (see page 36) 1. Connect a digital output from the source device to Opt 1 / 2 or Coax 1 /2 2. Select "Bitstream" or "Raw" as the data format on the source device (referring to the instructions given for the source device) 1. Set "dynamic" (m => System Setup => Dynamic) to „comp", under "Output Config" (m => System Setup => Output Config => Input) select "zone 1" as the input and on the main screen select the desired source as input 2. Increase the volume for Zone2 - output under "Volume" (m => System Setup => Output Config => Volume) 1. Set the system to 2.1 mode under "system preset" (m => System Setup => factory setup => System Preset) Distorted radio reception A set radio station is no longer available once the system has been switched off and on again (display back on 87.50) Sound and image are not (lip)synched 1. Poor aerial position 2. Poor geographical location 3. The station has not been properly set 1. The station was not allocated a programme slot 1. Long processing times in the TV delay the image 1. Arrange the extended (!) aerial as openly as possibly, well away from metal surfaces 2. Use a roof-mounted aerial or a broadband cable connection 3. Tune the station manually, following the instructions on page 39 1. Simply press the "OK" key to save a station in Programme Slot 1 1. Delay the sound in "lip sync" (m => System Menu => lip sync) so that the image and sound are synchronised (simulta neous) 45