Canton DM 20 Owners Manual - Page 46
DM System -> Volume, DM System - Sound
View all Canton DM 20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
DM System -> Volume No (music) playback Volume will not go above a certain value (System Setup => factory set => line2 config) 1. Set the volume limiter (m => System Setup => factory set => max volume) to the desired value (max. 99) 1. Set the "start volume" (m => System Setup => factory set => start volume) to the desired value (max. 99 but not higher than "max volume") 1. In the Loudspeaker Menu use (m => Speaker Setup => Level Trim) to set the correct volume levels and (m => Speaker Setup => Speaker Distance) to set the correct distances DM System - Sound In Surround Mode there is little or no surround sound 1. The Play Mode is set on "stereo" or "wide" 2. The listening spot is not central enough 3. The source only supplies a 2-channel signal 4. The DM System is set to 4.1/5.1 mode 46 1. Set Play Modes to "surround 1" or "surround 2" 2. In the Loudspeaker Menu use (m => Speaker Setup => Level Trim) to set the correct volume levels and (m => Speaker Setup => Speaker Distance) to set the correct distances to the listening spot 3. To achieve optimal sound in the room the DM System requires a multi-channel data stream. In this case the RC displays "virtual Dolby Digital" or "virtual DTS". All other displays (e.g. "Virtual Dolby PLII) mean that it is not a multichannel data stream, which leads to less of a surround sound impression 4. Set the system to a 2.1 Mode with virtual surround-mode at "System Preset" (m => System Setup => factory setup => System Preset)