Casio XJ-H2600 User Manual - Page 55

Problem Cause and Recommended Action Text is blurry. z The image may be out of focus. Rotate the focus ring to focus. z The current frequency and/or phase setting do not match the input signal. (Applies only when the input source is an RGB signal.) Press the [AUTO] key to execute an automatic adjustment operation. z On the setup menu, perform the "Image Adjustment 2 J Frequency" and "Image Adjustment 2 J Phase" adjustments. (Applies only when the input source is an RGB signal.) See page 40. z If the input source is a video camera or document camera, check to make sure there is no problem with the input source device. The message "Please input the password." appears and further operation is not possible. The "Option Settings 1 J Password protection J Power On Password" setting on the setup menu is turned on, so the projector is password protected. Input the correct password, and then press the [ENTER] key. See page 32. The remote controller does z The remote controller batteries may be dead. Replace the batteries. not work. z The remote controller may be too far from the projector. Make sure the remote controller is within the allowable range when you operate it. See page 56. The TEMP or LIGHT An error occurred. See "Error Indicators and Warning Messages" (page 51). indicator is flashing or lit. The light source unit does The light source unit has reached the end of its service life or it is malfunctioning. not light. Contact your original dealer or authorized CASIO service center for replacement. Important! z Try performing the following steps, which may or may not return the projector to normal operation. 1. Unplug the AC power cord and wait for at least 10 minutes. 2. Plug the power cord back in and turn the projector back on again. z If normal operation does not resume after you perform the above steps, take the projector to your retailer or authorized CASIO service center. 55