Casio XJ-ST145 User Guide - Page 10

Operation During Projection Selecting the Input Source Turning on the projector initially causes the same input source that was selected the last time it was turned off to be selected. To select a different input source 1. Press the [INPUT] key. z This displays the input source selection screen. 2. Select either the Normal Input Mode or 3D Input Mode depending on the type of image you want to project. z For details about the 3D Input Mode, see the explanation in the following section. 3. Use the [T] and [S] keys to select the name of the input source you want to select and then press the [ENTER] key. z The name of the input source you select appears in the upper right corner of the projection screen for a few seconds. z The message "No signal input." will appear if no input signal can be selected. Note The table below shows how the input source selection affects the projector's MONITOR OUT terminal and speaker (or AUDIO OUT terminal)*1 output signals. When this input source is selected: The video input signal from this The audio input signal from this terminal is output to the terminal is output to the speaker MONITOR OUT terminal: (or AUDIO OUT terminal): Computer 1 Computer 2 S-video Video HDMI USB COMPUTER IN 1*2 COMPUTER IN 2*2 *2 *3 *2 *3 *2 *3 *2 *3 AUDIO IN 1 AUDIO IN 2 AUDIO IN L/R AUDIO IN L/R HDMI USB *1 Audio is output from either the speaker or AUDIO OUT terminal in accordance with the setup menu "Option Settings 2 J Audio Output" setting. *2 Output is proper only when the input signal is an RGB signal. Output is not guaranteed when the input signal is a component signal. *3 The video input signal is output from either Computer 1 or Computer 2, in accordance with the last selected input source (COMPUTER IN 1 terminal or COMPUTER IN 2 terminal). For example, even if the input source is switched from Computer 1 to S-video, the MONITOR OUT terminal continues output the video input signal from COMPUTER IN 1. 10