Cisco 3750G Configuration Guide - Page 462

Understanding RSTP Chapter 19 Configuring MSTP • Backup port-Acts as a backup for the path provided by a designated port toward the leaves of the spanning tree. A backup port can exist only when two ports are connected in a loopback by a point-to-point link or when a switch has two or more connections to a shared LAN segment. • Disabled port-Has no role within the operation of the spanning tree. A port with the root or a designated port role is included in the active topology. A port with the alternate or backup port role is excluded from the active topology. In a stable topology with consistent port roles throughout the network, the RSTP ensures that every root port and designated port immediately transition to the forwarding state while all alternate and backup ports are always in the discarding state (equivalent to blocking in IEEE 802.1D). The port state controls the operation of the forwarding and learning processes. Table 19-2 provides a comparison of IEEE 802.1D and RSTP port states. Table 19-2 Port State Comparison Operational Status Enabled Enabled Enabled Enabled Disabled STP Port State (IEEE 802.1D) Blocking Listening Learning Forwarding Disabled RSTP Port State Discarding Discarding Learning Forwarding Discarding Is Port Included in the Active Topology? No No Yes Yes No To be consistent with Cisco STP implementations, this guide defines the port state as blocking instead of discarding. Designated ports start in the listening state. Rapid Convergence The RSTP provides for rapid recovery of connectivity following the failure of a switch, a switch port, or a LAN. It provides rapid convergence for edge ports, new root ports, and ports connected through point-to-point links as follows: • Edge ports-If you configure a port as an edge port on an RSTP switch by using the spanning-tree portfast interface configuration command, the edge port immediately transitions to the forwarding state. An edge port is the same as a Port Fast-enabled port, and you should enable it only on ports that connect to a single end station. • Root ports-If the RSTP selects a new root port, it blocks the old root port and immediately transitions the new root port to the forwarding state. • Point-to-point links-If you connect a port to another port through a point-to-point link and the local port becomes a designated port, it negotiates a rapid transition with the other port by using the proposal-agreement handshake to ensure a loop-free topology. As shown in Figure 19-4, Switch A is connected to Switch B through a point-to-point link, and all of the ports are in the blocking state. Assume that the priority of Switch A is a smaller numerical value than the priority of Switch B. Switch A sends a proposal message (a configuration BPDU with the proposal flag set) to Switch B, proposing itself as the designated switch. After receiving the proposal message, Switch B selects as its new root port the port from which the proposal message was received, forces all nonedge ports to the blocking state, and sends an agreement message (a BPDU with the agreement flag set) through its new root port. 19-10 Catalyst 3750 Switch Software Configuration Guide OL-8550-02