Cisco 3750G Configuration Guide - Page 694

Configuring IPv4 ACLs Chapter 32 Configuring Network Security with ACLs Numbered ACLs In this example, network 36.0.0.0 is a Class A network whose second octet specifies a subnet; that is, its subnet mask is 255.255.0.0. The third and fourth octets of a network 36.0.0.0 address specify a particular host. Using access list 2, the switch accepts one address on subnet 48 and reject all others on that subnet. The last line of the list shows that the switch accepts addresses on all other network 36.0.0.0 subnets. The ACL is applied to packets entering a port. Switch(config)# access-list 2 permit 36.48.0.3 Switch(config)# access-list 2 deny 36.48.0.0 0.0.255.255 Switch(config)# access-list 2 permit 36.0.0.0 0.255.255.255 Switch(config)# interface gigabitethernet2/0/1 Switch(config-if)# ip access-group 2 in Extended ACLs In this example, the first line permits any incoming TCP connections with destination ports greater than 1023. The second line permits incoming TCP connections to the Simple Mail Transfer Protocol (SMTP) port of host 128.88.1.2. The third line permits incoming ICMP messages for error feedback. Switch(config)# access-list 102 permit tcp any 128.88.0.0 0.0.255.255 gt 1023 Switch(config)# access-list 102 permit tcp any host 128.88.1.2 eq 25 Switch(config)# access-list 102 permit icmp any any Switch(config)# interface gigabitethernet2/0/1 Switch(config-if)# ip access-group 102 in For another example of using an extended ACL, suppose that you have a network connected to the Internet, and you want any host on the network to be able to form TCP connections to any host on the Internet. However, you do not want IP hosts to be able to form TCP connections to hosts on your network, except to the mail (SMTP) port of a dedicated mail host. SMTP uses TCP port 25 on one end of the connection and a random port number on the other end. The same port numbers are used throughout the life of the connection. Mail packets coming in from the Internet have a destination port of 25. Outbound packets have the port numbers reversed. Because the secure system of the network always accepts mail connections on port 25, the incoming and outgoing services are separately controlled. The ACL must be configured as an input ACL on the outbound interface and an output ACL on the inbound interface. In this example, the network is a Class B network with the address 128.88.0.0, and the mail host address is 128.88.1.2. The established keyword is used only for the TCP to show an established connection. A match occurs if the TCP datagram has the ACK or RST bits set, which show that the packet belongs to an existing connection. Gigabit Ethernet interface 1 on stack member 1 is the interface that connects the router to the Internet. Switch(config)# access-list 102 permit tcp any 128.88.0.0 0.0.255.255 established Switch(config)# access-list 102 permit tcp any host 128.88.1.2 eq 25 Switch(config)# interface gigabitethernet1/0/1 Switch(config-if)# ip access-group 102 in Named ACLs This example creates a standard ACL named internet_filter and an extended ACL named marketing_group. The internet_filter ACL allows all traffic from the source address 1.2.3.4. Switch(config)# ip access-list standard Internet_filter Switch(config-ext-nacl)# permit 1.2.3.4 Switch(config-ext-nacl)# exit 32-24 Catalyst 3750 Switch Software Configuration Guide OL-8550-02