Cisco 3845 Hardware Guide - Page 127
Installing a PVDM
![]() |
UPC - 746320981420
View all Cisco 3845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Figure 64 PVDM Polarization Notch PVDM Installation and Removal 103363 Polarization notch Alignment holes Installing a PVDM To install a PVDM, follow these steps: Note Install PVDMs beginning with the PVDM 0 connector. Step 1 Step 2 Step 3 Locate the PVDM connector on the motherboard. See Figure 51 and Figure 52 for PVDM connector locations. Orient the PVDM so that the polarization notch lines up with the key on the connector. See Figure 64. Hold the PVDM at an angle and insert it carefully into the PVDM connector. Tilt the PVDM up to the vertical position so that the clips snap into place at both ends. See Figure 65. Figure 65 Installing a PVDM 2 1 2 103469 1 Tilt PVDM up to vertical 2 Clips snap into place OL-5975-04 Installing and Upgrading Internal Components in Cisco 3800 Series Routers 97
![](/manual_guide/products/cisco-cisco3825acip-hardware-guide-822488c/127.png)