Cisco 4908G-L3 Installation Guide - Page 85
To use the CLI to perform additional configuration or management tasks, enter
UPC - 746320303703
View all Cisco 4908G-L3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Appendix B Initial Configuration for the Switch Entering the Initial Configuration Information Interface Protocol Vlan1 up FastEthernet1 up IP-Address 172.16.1.2 unassigned OK? Method YES manual YES unset Status up up !--- Output suppressed. Switch1# show ip route Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - ISIS level-1, L2 - ISIS level-2, ia - ISIS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is 172.16.1.1 to network 0.0.0.0 172.16.0.0/24 is subnetted, 1 subnets C 172.16.1.0 is directly connected, Vlan1 S* 0.0.0.0/0 [1/0] via 172.16.1.1 Switch1# Step 15 Save the running configuration: Switch1# copy system:running-config nvram:startup-config You have now completed the initial configuration of the switch. To use the CLI to perform additional configuration or management tasks, enter commands at the Switch> prompt through the console port by using a terminal program or through the network by using Telnet. For configuration information, refer to the switch software configuration guide or the switch command reference. 78-18039-02 Catalyst 4900 Series Switch Installation Guide B-7