Cisco ASA5550-BUN-K9 Hardware Installation Guide - Page 39
Removing the Power Supply Screws, Disconnecting the Power Connector
UPC - 882658096334
View all Cisco ASA5550-BUN-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Chapter 4 Maintenance and Upgrade Procedures Removing and Replacing the Power Supply Step 6 Lift the rear of the chassis from the surface and unscrew both the screws that secures the power supply to the chassis, as shown in Figure 4-5. Figure 4-5 Removing the Power Supply Screws FLASH POW ER STATUS ACTIVE VPN FLASH 119581 1 1 Chassis bottom Step 7 Step 8 Locate the power connector on the system board. Unlatch the plug, then grasp the sides of the power connector and pull upward while rocking the connector from side to side. Disconnect the power connector from the system board as shown in Figure 4-6. Figure 4-6 Disconnecting the Power Connector 1 119639 2 1 AC power supply 2 Power connector 78-17989-01 Cisco ASA 5500 Series Hardware Installation Guide 4-5