Cisco CISCO1701-K9-RF Hardware Installation Guide - Page 157
Installing a Daughter Card on the HWIC-D-9ESW Card, Verifying Daughter Card Installation
UPC - 746320858944
View all Cisco CISCO1701-K9-RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
10/100BASE-T Ethernet Switch High-Speed WAN Interface Cards Installing Inline Power Daughter Cards on Cisco 10/100BASE-T Ethernet Switch HWICs Installing a Daughter Card on the HWIC-D-9ESW Card To install an inline power daughter card on the HWIC-D-9ESW card, perform the following steps: Step 1 Install the four standoffs (included with the daughterboard) onto the HWIC motherboard, as shown in Figure 112, with the provided fastening screws. Tighten the screws firmly. Figure 112 Installing an Inline Power Card on the Cisco 10/100BASE-T Ethernet Switch HWICD-9ESW Card 1 4 4 2 2 2 2 5 5 103114 3 1 Fastening screws: daughter card to standoffs 4 Daughter card connectors 2 Standoffs 5 Motherboard connectors 3 Fastening screws: standoffs to motherboard Step 2 Step 3 Plug the daughter card connectors into the motherboard connectors, making sure that the standoffs align correctly underneath the mounting holes in the daughter card. Connect the daughter card to the standoffs with the provided fastening screws. Tighten the screws firmly. Verifying Daughter Card Installation Perform the following steps to verify correct installation of the daughter card: Step 1 Install the HWIC into the router and power up the router. Step 2 Issue the show power inline command. OL-12850-01 5