Cisco CISCO1701-K9-RF Hardware Installation Guide - Page 36
Clause 1.2.14.3 Service Personnel.
UPC - 746320858944
View all Cisco CISCO1701-K9-RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Recommended Practices for Cisco Interface Cards Installing Cisco Interface Cards in Cisco Access Routers The following warnings apply in Australia: Warning Do not touch the power supply when the power cord is connected. For systems with a power switch, line voltages are present within the power supply even when the power switch is OFF and the power cord is connected. For systems without a power switch, line voltages are present within the power supply when the power cord is connected. Statement 4 Warning Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals. Statement 43 Warning This equipment is to be installed and maintained by service personnel only as defined by AS/NZS 3260 Clause 1.2.14.3 Service Personnel. Statement 88 Warning This equipment will be inoperable when mains power fails. Statement 198 Warning Incorrect connection of this or connected equipment to a general purpose outlet could result in a hazardous situation. Statement 212 Warning Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable is connected, avoid exposure to laser radiation and do not stare into open apertures. Statemen125 Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement 1001 Warning To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Both LAN and WAN ports may use RJ-45 connectors. Use caution when connecting cables. Statement 1021 Warning Hazardous network voltages are present in WAN ports regardless of whether power to the router is OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables, detach the end away from the router first. Statement 1026 Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040 OL-12842-01 4