Cisco ESW-540-8P Administration Guide - Page 14
Default Configuration settings on the ESW 500 Series Switches, Physical Connectivity - 24p
UPC - 882658304057
View all Cisco ESW-540-8P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Getting Started Typical Installation Methods 1 In the third scenario, called Heterogeneous Network, you are adding an ESW 500 switch to a network which does not have any Cisco Small Business products. Default Configuration settings on the ESW 500 Series Switches The ESW 500 series switches ship with a default configuration that enables simplified installation and plug and play when connected into a Cisco Small Business network such as SBCS. The default settings are as follows: • Management VLAN is VLAN 1 • Management IP Address is obtained via DHCP by default. If the switch times out on a Dynamic Host Configuration Protocol (DHCP) response, it falls back to a static IP address 192.168.10.2 with subnet mask of 255.255.255.0. • Voice VLAN is VLAN 100 • Cisco Discovery Protocol (CDP) is enabled on all ports Physical Connectivity Physical connections to the switch are described in the tables and graphics on the next two pages. Uplink Ports ESW 500 Series Switch Copper SFP (mini-GBIC) ESW 520-8P GE1 GE1 ESW 540-8P GE1 GE1 ESW 520-24/24P GE1-GE4 GE3-GE4 ESW 520-48/48P GE1-GE2 GE3-GE4 ESW 540-24/24P 11-12, 23-24 GE1-GE4 ESW 540-48 23-24, 47-48 GE1-GE4 Layer 2 Ethernet Ports 1-8 1-8 1-24 1-48 1-10, 13-22 1-22, 25-46 NOTE On the 8 port devices, the Uplink and the GBIC ports can not be used at the same time. ESW 500 Series Switches Administration Guide 3