Cisco ESW-540-8P Administration Guide - Page 321
Edit Bandwidth Configuring Quality of Service
![]() |
UPC - 882658304057
View all Cisco ESW-540-8P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 321 highlights
Configuring Quality of Service Defining General Settings Edit Bandwidth Page 12 The Edit Bandwidth Page contains the following fields: • Interface - Indicates whether the interface, for which bandwidth settings are edited, is a port or a EtherChannel. • Enable Egress Shaping Rate - Indicates if shaping is enabled on the interface. The possible field values are: - Checked - Enables egress shaping on the interface. - Unchecked - Disables egress shaping on the interface. • Committed Information Rate (CIR) - Defines CIR as the queue shaping type. The possible field values are: - For FE ports, the rate is 64 - 62,500 Kbps. - For GE ports, the rate is 64 - 1,000,000 Kbps. • Committed Burst Size (CbS) - Defines CbS as the queue shaping type. CbS is supported only on GE interfaces. The possible field value is 4096 - 16,769,020 bytes. • Enable Ingress Rate Limit - Indicates if rate limiting is defined on the interface. The possible field values are: - Checked - Enables ingress rate limiting on the interface. - Unchecked - Disables ingress rate limiting on the interface. • Ingress Rate Limit - Defines the amount of bandwidth assigned to the interface. ESW 500 Series Switches Administration Guide 310
![](/manual_guide/products/cisco-esw5408p-administration-guide-521acb4/321.png)