Cisco ESW-540-8P Administration Guide - Page 214

Configuring Ports Port Settings 6 • Port Type - Displays the port type. The possible field values are: - 100M - Copper - 1000M - Copper (copper cable). - 1000M - ComboC (combo port with copper cable 3). - 1000M - ComboF (combo port with optic fiber cable). - 1000M FiberOptics - Indicates the port has a fiber optic port connection. • Port Status - Displays the port connection status. The possible field values are: - Up - Port is connected. - Down - Port is disconnected. • Port Speed - Displays the current port speed. • Duplex Mode - Displays the port duplex mode. This field is configurable only when auto negotiation is disabled, and the port speed is set to 10M or 100M. This field cannot be configured on EtherChannels. The possible field values are: - Full - Indicates that the interface supports transmission between the device and the client in both directions simultaneously. - Half - Indicates that the interface supports transmission between the device and the client in only one direction at a time. • PVE - Indicates that this port is protected by an uplink, so that the forwarding decisions are overwritten by those of the port that protects it. • EtherChannel - Defines if the port is part of a Link Aggregation Group (EtherChannel). STEP 2 To copy the settings from one interface to another, enter the specific interface numbers in the Copy From Entry Number and To Entry Number(s) fields. STEP 3 Click Apply. The Port Settings are defined, and the device is updated. ESW 500 Series Switches Administration Guide 203