Cisco PAP2T User Guide - Page 13

Internet Phone Adapter with 2 Ports for Voice-over-IP Interactive Voice Response Menu Action Enable/Disable DHCP Check IP Address Set Static IP Address Check Network Mask (or Subnet Mask) Set Network Mask (or Subnet Mask) Check Static Gateway IP Address Set Static Gateway IP Address Command (press these keys on the telephone) 101 110 111 120 121 130 131 Choices Enter 1 to enable Enter 0 to disable - Enter the IP address using the numbers on your telephone keypad. Use the * (star) key to enter a decimal point. - Enter the network mask using numbers on your telephone keypad. Use the * (star) key to enter a decimal point. - Enter the IP address using numbers on your telephone keypad. Use the * (star) key to enter a decimal point. Description Enable or disable the Phone Adapter's DHCP feature. If your network router assigns IP addresses, enter 1, otherwise, enter 0. Use this command to check the current IP address of the Phone Adapter. To set a static IP address, the DHCP feature must be disabled. If the DHCP feature is enabled, you will hear, "Invalid Option," if you try to set a static IP address. Use this command to check the current network mask of the Phone Adapter. To set the network mask, the DHCP feature must be disabled. If the DHCP feature is enabled, you will hear, "Invalid Option," if you try to set the network mask. Use this command to check the current gateway IP address of the Phone Adapter. To set a static gateway IP address, the DHCP feature must be disabled. If the DHCP feature is enabled, you will hear, "Invalid Option," if you try to set a static gateway IP address. Chapter 4: Using the Phone Adapter's Interactive Voice Response Menu 9 Using the Interactive Voice Response Menu