Cisco SLM2008PT-NA Administration Guide - Page 26

Configuring LACP Settings, Port > Static Link Aggregation

Page 26 highlights

Advanced Configuration Port 5 The Port > Static Link Aggregation window displays the current static link aggregation settings. To configure static link aggregation, follow these steps: STEP 1 Click Port > Static Link Aggregation. STEP 2 LAG displays the LAG number. Select the Port numbers to add the port to the LAG group. STEP 3 Click Save. Configuring LACP Settings Ports can be statically grouped into an aggregate link (that is, LAG) to increase the bandwidth of a network connection or to ensure fault recovery. Or you can use the Link Aggregation Control Protocol (LACP) to automatically negotiate a LAG link between the switch and another network device. For dynamic LAGs, the switches have to comply with LACP. This switch supports up to two LAGs. For example, a LAG consisting of two 1000 Mbps ports can support an aggregate bandwidth of 4 Gbps when operating at full duplex. Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66

Advanced Configuration
Port
Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide
21
5
The Port > Static Link Aggregation window displays the current static link
aggregation settings.
To configure static link aggregation, follow these steps:
STEP 1
Click
Port > Static Link Aggregation
.
STEP 2
LAG
displays the LAG number. Select the Port numbers to add the port to the LAG
group.
STEP 3
Click
Save
.
Configuring LACP Settings
Ports can be statically grouped into an aggregate link (that is, LAG) to increase the
bandwidth of a network connection or to ensure fault recovery. Or you can use the
Link Aggregation Control Protocol (LACP) to automatically negotiate a LAG link
between the switch and another network device. For dynamic LAGs, the switches
have to comply with LACP. This switch supports up to two LAGs. For example, a
LAG consisting of two 1000 Mbps ports can support an aggregate bandwidth of 4
Gbps when operating at full duplex.