Cisco SPA112 Administration Guide - Page 104
Audio Configuration, G729a. Default setting: Unspecified
View all Cisco SPA112 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Configuring Voice Configuring Voice Settings 4 Field Enable IP Dialing Emergency Number Mailbox ID Audio Configuration Description Enable or disable IP dialing. If IP dialing is enabled, one can dial [userid@] a.b.c.d[:port], where '@', '.', and ':' are dialed by entering *, userid must be numeric (like a phone number) and a, b, c, d must be between 0 and 255, and port must be larger than 255. If port is not given, 5060 is used. Port and User-Id are optional. If the userid portion matches a pattern in the dial plan, then it is interpreted as a regular phone number according to the dial plan. The INVITE message, however, is still sent to the outbound proxy if it is enabled. Default setting: No Comma separated list of emergency number patterns. If outbound call matches one of the pattern, the SRP will disable hook flash event handling. The condition is restored to normal after the call ends. Blank signifies that there is no emergency number. Maximum number length is 63 characters. Default setting: blank Enter the ID number of the mailbox for this line. Field Preferred Codec Second Preferred Codec Description Preferred codec for all calls. (The actual codec used in a call still depends on the outcome of the codec negotiation protocol.) Select one of the following: G711u, G711a, G726-32, or G729a. Default setting: G711u Second preferred codec for all calls. (The actual codec used in a call still depends on the outcome of the codec negotiation protocol.) Select one of the following: Unspecified, G711u, G711a, G726-32, or G729a. Default setting: Unspecified Cisco SPA100 Series Phone Adapters Administration Guide 104