Cisco SPA112 Administration Guide - Page 86

Configuring Voice Configuring Voice Settings 4 Field Feature Dial Services Codes Description These codes tell the ATA what to do when the user is listening to the first or second dial tone. One or more *codes can be configured into this parameter, such as *72, or *72|*74|*67|*82, etc. The maximum length is 79 characters. This parameter applies when the user has a dial tone (first or second dial tone) After receiving dial tone, a user enters the *code and the target number according to current dial plan. For example, after user dials *72, the ATA plays a special tone called a Prompt tone while awaiting the user to enter a valid target number. When a complete number is entered, the ATA sends a INVITE to *72 target_number as in a normal call. This feature allows the proxy to process features like call forward (*72) or Block Caller ID (*67) The *codes should not conflict with any of the other vertical service codes internally processed by the ATA. You can remove a corresponding *code that you do not want to the ATA to process. You can add a parameter to indicate which tone plays after the *code is entered, such as *72'c'|*67'p'. Below is a list of allowed tone parameters (note the use of open quotes surrounding the parameter, without spaces) 'c' = 'd' = 'm' = 'o' = 'p' = 's' = 'x' = No tones are place, x is any digit not used above If no tone parameter is specified, the ATA plays Prompt tone by default. If the *code is not to be followed by a phone number, such as *73 to cancel call forwarding, do not include this parameter. Instead, add the *code in the dial plan and the ATA send INVITE *73@..... as usual when user dials *73. Cisco SPA100 Series Phone Adapters Administration Guide 86