Cisco VG202 Hardware Installation Guide - Page 32

Mounting Tools and Equipment Chapter 3 Installing Cisco VG202 and Cisco VG204 Voice Gateways Task Verified by Date Installation site prepower check completed Required tools available Additional equipment available Cisco VG received Quick start guide received Regulatory compliance and safety information received Information packet, warranty card, and Cisco.com card received Software version verified Rack, desktop, or wall-mounting of chassis completed Initial electrical connections established ASCII terminal attached to console port Modem attached to console port (for remote configuration) Signal distance limits verified Startup sequence steps completed Initial operation verified Mounting Tools and Equipment Obtain the following tools and parts to install Cisco VG202 and Cisco VG204 voice gateways: • Screws and anchors for wall-mounting - Eight wood screws or other fasteners, for installing the chassis on a wall. An additional starter screw can be used to facilitate wall-mounting. • ESD-preventive wrist strap In addition, you might need the following external equipment: • Console terminal or personal computer with terminal emulation software • PC running terminal emulation software for administrative access • Modem for remote access • Analog voice RJ-11 cable Unpacking and Inspection Do not unpack the Cisco VG202 or Cisco VG204 voice gateway until you are ready to install the equipment. If the installation site is not ready, keep the chassis in its shipping container to prevent accidental damage. The Cisco VG202 or Cisco VG204 voice gateway, cables, and any optional equipment that you ordered might be shipped in more than one container. When you unpack each shipping container, check the packing list to ensure that you received all the following items: • Cisco VG202 or Cisco VG204 voice gateway Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide 3-4 OL-15959-01